P1S/P2S/X2D riser - Manual Grille, Side Pegboard

This model is a P1S, P2S, X2D Top Glass Lid Riser, which can raise the lid by 27mm, enhancing ventilation and effectively preventing the filament tube from rubbing against the top glass. It features 4 manually opening/closing grilles, side IKEA Skadis pegboards, and is characterized by fast printing, simple, and secure assembly. Single plate print, no supports, requires less than 300g filament. 27mm raised height, perfectly avoids filament tube rubbing. 4 manual ventilation grilles front and back, for quick switching between ventilation and chamber temperature. IKEA pegboards on both sides, universal attachments can be quickly installed and removed. Measured to original machine dimensions, perfectly compatible with P2S and other models (a P1S version is also available, found in print profile). Mortise and tenon assembly structure, fast and secure assembly. : Since the machine glass position is not square, the four-sided clips have an anti-foolproof design (please assemble according to the corresponding numbers), please arrange the installation direction in advance when installing: 1. The ventilation grilles are located on the front and back of the riser, and all pegboards are on the sides. 2. If you find it doesn't fit after assembly, it means you assembled it incorrectly, just disassemble and reassemble. Four-sided ventilation model assembly: 1. Please assemble according to the corresponding numbers, the top screw recess should be at the front of the machine, used to e